Denso Universal Oxygen Sensor is designed with precision, manufactured to the highest O.E. quality, guaranteed to fit right the first time. This oxygen sensor is of superior quality and will outlast most other oxygen sensors. Constructed with exclusive aluminum oxide trap, this extra layer helps to protect from silicone and lead poisoning which causes premature sensor failure. This combined with other Denso high quality features such as stainless steel housing and porous Teflon filter all contribute to make a long life oxygen sensor with improved engine performance and greater fuel efficiency.
With so many on offer these days, it is great to have a name you can trust. This item is certainly that and will be a perfect buy. The distributor have added some great touches and this equals great value.
You can trust this review, i hope you can try to buy this product and then you know this product good or no. Next time you can make a review for another people.
Near-perfect replacement
After removing the original sensor that had failed, I installed this one, using the original wiring/plug. The wiring for the original one seemed a little short, so I installed this one with 1" more cable - you can't do that with the OEM replacement.
I chose the Denso over other brands, because that is what the original was. The sensor body is identical to what was removed.
This was a fraction of the cost of a ready-to-install sensor, but it was well worth the effort to do a little work.
The only criticism is that the shrink-tubing provided to seal the splices seemed to take longer than I expected to shrink down. I used a Bic lighter, as I have done with other shrink tubing. It just seems like it took a long time to tighten up.
It's been in a month now, and seems to be working just fine.
A note when measuring to cut the original wiring: be sure to mark where all of the ties and clips are, where the harness is attached along its...
Click here to read the full review for more information about this product.
Didn't work for me
I bought this universal oxygen sensor to replace the rear one that was mounted on the catalytic converter on my 2000 Honda Civic Si. I bought the universal to save about $70 or so over the "exact fit" replacement. But looking back on it now, I wish I had just spent the extra money for the "exact fit" version. To use this universal unit, you must reuse the electrical connector (leaving a length of wire attached) from you old sensor. It comes with crimp connectors so that you can splice the wires together, but I didn't have a wire crimping tool, so I soldered the wires together with a 25 watt iron utilizing the solder holes found on the crimping connectors. Everything appeared to look good, but after installation the new sensor was reporting a constant 1.28 volts and my car's computer threw a code P0138 (too high a voltage). I'm ASSUMING that the heat from my soldering job caused a short somewhere in the sensor itself or in the old connector. Of course I cannot return the sensor...
Best O2 at Best Price Around
I still have yet to find a cheaper place to buy a 4-wire denso O2 sensor than here at Amazon. I never thought I'd be buying car parts on here, but if they want to sell it, I'm happy to buy it.
I replaced my Celicas sensor with this universal one in about 15 minutes using a socket I already had. The check engine light I had previously has disappeared & my fuel economy slightly improved. This is the same brand that most japanese manufacturers use as OEM equipment, such as Mazda, Toyota, Nissan. I've used Bosch universals in the past & this one is equivalent, but less expensive than the Bosch 4-wire counterparts.
Product Features :
- Manufactured to the highest O.E. quality, guaranteed to fit right
- Aluminum oxide trap, this extra layer helps to protect from silicone and lead poisoning
- Stainless steel housing and porous Teflon filter all contribute to make a long life
- Improved engine performance and greater fuel efficiency
- Prevents premature sensor failure
Rating : 3.8
List Price : $118.85
0 comments:
Post a Comment